Fuel Pump Fit For Chevy Corvette 5.7L 1989 1990 1991 1992 1993 1994 1995 1996

  
The Function of the fuel pump is to supply fuel at a certain pressure to the engine fuel injection system. However, the fuel pump have a limited life. If you notice any of the following signs with your car. Engine Sputtering at High Speeds.

Losing Power when the Vehicle is under Stress. This may indicate that you need to replace the fuel pump. Please Note the following before replacing the fuel pump. Fuel Pump Fit For Chevy Corvette 5.7L 1989 1990 1991 1992 1993 1994 1995 1996. Ensure that you are in a well ventilated and level work area.

Use approved safety glasses or goggles when working on any motor vehicle. The gasoline is sucked out of the tank and stored in a container dedicated to gasoline.

Disconnect the ground (negative) cable of the battery and ensure that it does not accidentally spark while working. Locate and remove gas tank filler neck mounting bolts or remove the filler tube from the tank.

This will aid the fuel removal especially if you had problems accessing through the filler neck. Located the electrical connector for the fuel pump and fuel level sender which will be in the same wiring harness. If access if difficult or you can't see them wait until the tank is lowered slightly to undo the connector. Inspect electrical connector for burns or heated spots and replace if damaged.

A burned connector can cause a pump to fail intermittently. There will be fuel vapor lines as part of the EVAP system these will need to be removed or disconnected.

Locate and release tank holder supports, there are two in most cases. Remove the mounting bolts at this point the tank will become loose but may not come out. Lower the tank and release top mounted fuel lines or electrical connectors if any.

Continue to remove the tank. Remove the tank, this will expose the fuel pump retainer ring. Use an aerosol cleaner to remove dirt and debris from the area. This will keep the inside of the fuel tank clean when performing the repair. Remove fuel pump mounting bolts or retainer ring to access the fuel pump module and remove the unit. Use a hammer and punch to remove the ring counterclockwise. Picture(I) Remove the fuel pump which will be attached to the mounting plate or positioned down inside the tank held by plastic retainer clips.

Remove the fuel pump from the tank. Fit For 2003 2004 Ford Expedition V8 5.4L Fuel Pump Assembly E2360M. For Chevy C1500 C2500 C3500 K1500 K2500 K3500 GMC C1500 C2500 C3500 Fuel Pump. For Pontiac G6 Chevy Malibu 2.4L 3.5L 3.6L 3.9L Saturn Aura 2.4L 3.5L Fuel Pump. For 2010 2011 2012 2013 Ford Transit Connect L4-2.0L Fuel Pump Assembly E2567M.

For Universal External Inline Fuel Pump Electric With Installation Kit 43 Psi.